Hey guys, I'm new here and looking to sell my car. It's a t top car that has been converted to a 5 speed. It only has 50k on the body, and less than 100 on the engine. There is no rust on the car! It has quite a bit done to it including : auburn posi(comes with new 4.10 gears in the box) 3.42 rear, the engine block is bored .040 over 350 4 bolt main, with splayed caps, with JE forged domes pistons , small chambered heads make 11:5:1 compression, 56cc heads, 2.02 stainless steel swirl polished valves, comp pro mag 1.62 roller rockers, monster 580 lift cam, geared timing eagle forged crank and H beam rods, JE forged pistons, also has eagle splayed mains, 2.02 heads with stainless steel valves , comp pro magnum 1.52 roller rockers, 580 lift cam with solid lifers , edlebrock surer victor intake, 4 inch carp spacer holly 750 cfm double pumper, full msd ignition,6al box with rev limiter , blaster 2 coil, and pro billet dist. , Pete Jackson Timing Gears, Open Headers, CE sub frame, 6 inch harwood cowel induction lift off hood (fiberglass)nnectors, Ram sfi clutch, hay sfi fly wheel, pressure plate, and harmonic balancer, (all NHRA approved) Engine was built by percision engine in Middletown Ny. The block is practically untouched as the car wasn't used much. had a bent valve, so I has Precision had Precision engines rebuild the heads( I have all the papers to prove this) I can also have the top end put back on, at buyers expense. If you're seriously interested, contact me beforehand. As for trades, I'm really looking for a slingshot, 270 or 600cc micro sprint, or a legends race car, maybe a street car. Try me. I have cash to add if neccessary.
See Full Classified Here
No comments:
Post a Comment